Home > News > Content

What About Splashing Water In Shower Room? Installation Details Should Not Be Overlooked!

- Jan 25, 2019 -

Many small partners choose the shower room at home, because of its wet and dry separation function, to a certain extent, it can effectively guarantee the cleanliness of the bathroom. But in the use process, some small partners will find that some shower room will have the problem of splashing water, in fact, this problem may be installed to pay attention to some, can effectively avoid. Let's take a look at it today. How should the shower room prevent splashing?

What about splashing water in the shower room? These installation details can not be ignored!

To do a good job of waterproofing shower room, first of all, we need to choose appropriate waterproofing materials, and secondly, we need standard waterproofing construction, so that we can ensure good waterproofing effect.

The shower room belongs to the stable part of the house structure, at the same time, the area is narrow and many pipes have long-term contact with water, so the requirement for waterproofing is relatively high. The most easily seepage part of the shower room is concentrated in Yinyang angle, through pipes, sanitary ware, and the periphery of ground leakage. Therefore, it is recommended to use kitchen and toilet waterproofing slurry when waterproofing, and to use quick-setting repairing mortar first, it will be easy to seep. Leakage repair and reinforcement, and then use the prepared permanent waterproof slurry as a whole to do waterproofing, so that the special waterproofing effect is certainly better than the general material effect.

As for construction, the floor of shower room needs to be waterproof. The wall should be at least 1.8 meters high. It is suggested that the floor should be full height. If it is a light wall, it must be full height. These installation details should not be overlooked:

First, bathroom floor leveling, for new or redecorated users. If you want to replace the floor tiles in the bathroom. After the original floor tiles are chiseled away, you must first leveling the floor with cement mortar, and then waterproof treatment. This can avoid leakage of waterproof coating due to uneven thickness.

Second, the joint should be painted to the seam between the toilet wall and the ground, and the joint between the upper and lower water pipes and the ground, which is the most prone place to problems. During construction, decoration workers must be urged to handle these edges and corners, and all waterproof coatings must be smeared "in place".

3. Wall treatment is also very important in the general bathroom waterproof treatment, the wall should also be made about 30 cm high waterproof paint, in order to prevent water seepage through the wall. But if the bathroom wall is a non-load-bearing light wall, it is necessary to coat the whole wall with waterproof paint. If you use two-fan shower screens, the two connected walls should also be painted. If you use a bathtub, the wall adjacent to the bathtub. The height of the waterproof coating is also higher than that of the upper edge of the bathtub.

4. Waterproof experiment is indispensable. After the construction of the toilet is completed, all the sewage of the toilet is blocked, and a 25 cm high "canal" is built at the door, and then 20 cm high water is poured into the toilet. After 24 hours, check the surrounding walls and ground for leakage. This 24-hour waterproofing test is the key to ensure the quality of the toilet waterproofing project.

Fifth, keep the sewage unobstructed all the sewer pipes in the toilet, including floor drain, sanitary ware and so on. Keep it open.


Previous: No Information

Next: Bathtub Tips

Related News

Related Products

  • Bathroom Unique Design Art Basin Sink
  • Curvature Acrylic Solid Basin
  • Standard Pedestal Sink
  • Modern Wall Mounted Sinks
  • Solid Surface Alcove Bathtub
  • Deep Square Shower Tray