Home > News > Content

Come Home With Bathtub

- Dec 01, 2017 -

The cast iron bathtub should be thoroughly rinsed with water after each use and wiped dry with a soft cloth. In case of stubborn stains, use a small amount of abrasive cleaning agent for cleaning. Clean the bottom non-slip surface with a soft nylon brush. Do not use steel wire ball, wire brush or abrasive sponge brush. Wash the Jacuzzi system twice or more per month. Adjust the nozzle clockwise until it closes completely to prevent air leakage.

1, warm water into the bathtub to 2 inches above the highest nozzle, or leave the water in the bathtub after use. Add two tablespoons of low foam, powdery dishwashing detergent and a small amount of household bleach to the water. Turn on the jacuzzi for 5 to 10 minutes and then shut it off to drain the water, then rinse the bathtub surface with water. Long-term hot and cold baths in the state, but also breed a lot of bacteria, sometimes cleaned, the surface looks clean, in fact, there are still many bacteria. It is recommended to regularly wipe the surface of the bathtub with water, do not use sterile water, because disinfection of water may not kill mold and fungi.

2, gentle treatment of surface stains You can use discarded soft bristle brush bleached bleach water scrub the surface, both to remove stains, but also to eliminate mold. Encountered hard to rub the stain, you can also use half a lemon dip in salt, you can also use a soft toothbrush coated whitening toothpaste scrub, turpentine is also very good at this time. For scale, the products used to clean the toilet on weekdays are good. If you do not like the pungent taste, you can use lemon and white vinegar in a more natural way.

3, timely repairs wound bathtub installed Do not move privately, you need to move the location, you must contact a professional. Do not beat with hard objects, impact the surface, resulting in bumps or scratches.

4, ready to deal with pipe clogging and timely disinfection of the pipe to clean once or twice a week, to clear the taste, and secondly to prevent the growth of bacteria. Can be used to clean the sewer products, into the sewer, clean after 5 minutes, be careful not to be used in metal tubes. Bath block if blocked, the valve can be closed to the water, and then put the right amount of tap water in the bathtub; the rubber suction (to clear the toilet with) placed on the water valve; open the drain valve at the same time, bored in the basin or Tub overflow hole; then quickly up and down to attract, dirt or hair sucked out, promptly cleaned. In the case of more serious congestion, you can repeat several times, until the clean up.


Related News

Related Products

  • Standard Pedestal Sink
  • Bathroom Basins
  • Solid Surface Alcove Bathtub
  • Stone Resin vs Acrylic
  • Corner Deep Shower Tray
  • Deep Square Shower Tray