1, prepare the necessary use tools.
2, install bottom basin: combine the bottom basin parts, adjust the bottom basin level, ensure the basin, the pot bottom no water. The hose can be telescopic with distance and close to the floor drain.
3, test, protection: after loading, test water needs to be tested, in order to ensure that the water is unimpeded. Four, finding and punching: using a pencil and a horizontal ruler to determine the drilling position of the aluminum material against the wall, and punch holes with a percussion drill.
4, the installation of aluminum in hole in rubber, screw the aluminum lock on the wall.
5, fixed glass: lock the glass clamp at the hole in the bottom of the bottom, and fix it with screws.
6, install the pipe: find the corresponding hole above the fixed glass, install the fixed seat (straight / oblique) and connect the pipe. Fix it on the top of the glass with a elbow sleeve.
7, installation of material rack: accurate position installation fixture, tighten laminates nut, fixed laminate glass, maintain vertical and horizontal. Pay attention to waterproof under the aluminum material of the fixed glass.
8, the installation of doors: hardware installed door hinges, will be installed on the fixed door reserved hole. After loading, adjust the position of the shaft core of the lotus leaf to the best touch.
9, good waterproof: in accordance with the requirements of the glass side or below the installation of a good suction bar or water retaining tape. The aluminum materials are seamed with the joints of the wall, glass and bottom basin with silica gel.
10, debugging, fastening: check whether the parts are comfortable and smooth, find problems should be adjusted in time. Adjust the corresponding screws after the adjustment, so that the whole shower room more firm.
11, finishing work: the decorative aluminum bar card into the wall aluminum material, to ensure that its appearance is neat and generous. At last, wipe out the whole shower room with a rag.